Handyman estimate

A handyman estimate template you can fill in on the job

A handyman estimate should still make sense when the customer reads it at the kitchen table. Start with the address where the work happens, even if the bill goes somewhere else. Put the day you will do the work next to the day the price expires. Fourteen days is a practical window for a faucet, a door, or a small patch of drywall. After that, the part you priced may not be the part on the shelf, and you should write a new number instead of honoring a stale one.

Split the price into lines a person can check. Labor is hours times your rate. If the faucet takes two and a half hours at your hourly rate, show both numbers. A single lump hides the time, and the argument later is always about the time. Materials are the parts you buy for that job: the faucet, the supply lines, the tape. If you front the money and stand behind the product, add a markup percent on that line. A markup of 15 percent on a part is easy to explain when it sits on the same line as the part. It is hard to explain when it is buried in a round number.

Charge the drive on its own line. Miles times a per-mile rate is honest when the job is across town. A flat haul-away is the right line when you are taking the old fixture to the dump and the miles are not the point. Do not hide the trip inside the labor rate and then forget the second visit. If you have to come back because a special-order part was wrong, that trip is a new line you agree before you roll.

Ask for a deposit before you open a wall or order something you cannot return. The sheet should show the total, the deposit, and the balance due, so the deposit is not mistaken for the whole bill. If you open the cabinet and the shutoff is rotten, stop and price that before you continue. Write what you found in the before notes and what you finished in the after notes. Those two short lines settle most disputes about what was already broken.

Tax is a percent you type. Fieldchit does not look up a rate, and this page is not tax or legal advice. If your state taxes parts and not labor, you still decide the percent, or you leave tax at zero and say so in the terms. The editor below is loaded with a handyman sample: faucet labor, parts with a markup, a trip, and haul-away. Replace the names with yours. When the customer says yes, turn the estimate into an invoice without retyping the lines. The PDF is made on this phone.

Open Fieldchit